Walkease Large 10 Pack Refill Foam Blocks

Description

• Can I use two Walkease blocks on one hoof?

  Walkease blocks can generally be attached safely to claws that are slightly damaged, although we would not recommend attaching over substantial abscesses or bruises. The Walkease glue is very thin so does not create any pressure points or fill any cavities. It is also safe to attach to flesh areas. In fact, cyanoacrylate glues are commonly used in human surgery for attaching to flesh or skin.

  Do I trim the Walkease block to size?

  Walkease blocks are supplied in four colour-coded sizes. First preference is to use the correct size block for the hoof being treated, so in almost all cases you should find one that fits. However, the block may need to be trimmed perhaps when the hoof is an unusual shape. If this is required, follow these guidelines:

  • The block should overlap the hoof outer wall by a few (4-6) millimeters so that the load bearing is contained within the block perimeter
  • If it is overlapping the hoof wall or heel too much the block is at risk of being caught by the hoof of another cow
  • The block should never be applied with the hoof wall hanging over the edge of the block

  What if I drop the Walkease block in dirt?

  A Walkease block can be cleaned with hot-detergent water, and then dried and kept clean until required.

  Should I rasp the Walkease block?

  No, this is not recommended.

  Will the Walkease blocks be secure on slat floors?

  If the block application has been done correctly, the blocks will handle the slats and gaps in floors. Because of their soft, flexible design Walkease don’t get jammed or ‘popped’ off like other blocks.

  What if the Walkease block comes off?

  If the Walkease glue is within its effective life (see section on storing glue), and the hoof was prepared as per the instructions for ‘hoof preparation’, then the blocks should not wear off for at least 10 to 14 days, even under very difficult conditions.

  If a block comes off and can be recovered, examine it, as it can give a clue as to what is causing any failure. The parts of the block that were attached to the hoof will be seen to have ripped the foam. The parts that have not attached will likely show contamination or areas where the glue has not been in good contact with the hoof. Read through the instructions and it may be apparent that a step was missed or perhaps not followed fully.

  Another idea is to try applying blocks to non-injured claws until you have solved the loss problem using other systems to block the injured claws. If the problem persists you should contact us, as we can offer technical advice.